EBR-SWB HANDLE WITH BISTABLE ELECTRICAL SWITCH

Belonging to the Ergostyle^® line, this handle is used when it is necessary for the switching to be prolonged over time. Through external logic, the Leds can be configured to indicate the specific status of the button (e.g. button in neutral position, green Led on, button switched on, red Led off).

The microswitch button is made up of a bistable normally open contact (NO).

The switching takes place by pressing the purple button, which stay switched until it is pressed again.

A red Led and a green Led can be configured through external logic to indicate the switch status.

EBR-SBW handle ensures an IP 65 protection class, according to EN 60529. This handle is equipped with an 8-pole connector or an 8-pole cable of 2.5 or 5m length for side or rear outputs.

EBR-SWB handle can be assembled with EBR neutral handle.

www.elesa-ganter.com